Back to article
3348
ADAPTiQ system setup and deactivation
Find out how to turn on or turn off ADAPTiQ audio calibration. ADAPTiQ optimizes the sound of your system for the acoustics of your room. The contents of your room (i.e. surfaces, furniture, rugs, etc.) impact how sound is heard in the room. The calibration process measures the properties of your room and adjusts the sound of your system accordingly. If you re-arrange your room or move your system to a different room, re-calibrate your system.
To run the ADAPTiQ audio calibration system:
Before you begin, be sure the speakers are connected placed where you want them.
- On the remote control, press the Power button to turn on your system
- Put the ADAPTiQ headset on your head. (Tip: Be sure the L and R letters on the headset are above your left and right ears)
- On the left side of the soundbar, slide open the cover to access the ADAPTiQ panel
- Plug in the ADAPTiQ headset to the ADAPTiQ jack. The light on the soundbar glows green and the calibration process begins (Tip: Press the ADAPTiQ button to scroll through the available languages, then press Vol + to select a language)
- Follow the voice prompts to calibrate your system
- Once complete, unplug the headset and slide the panel cover back in place
To turn off the ADAPTiQ audio calibration:
Note: This process erases the current ADAPTiQ audio calibration settings. To enable ADAPTiQ after, restart the audio calibration process.
- Power on your system
- On the left side of the soundbar, slide open the cover to access the ADAPTiQ panel
- Plug in the ADAPTiQ headset to the ADAPTiQ jack
- Hold the ADATPiQ button for about 10 seconds until you hear "ADAPTiQ has been set to its original factory settings"
- Unplug the AdaptIQ headset and replace the panel cover
Was this article helpful?
Thank you for your feedback!